Eversys Cameo range

Compact super-automatic espresso machines. E codes are faults, S codes stop production until you act, W codes are warnings; many are kept in the error history.

What it is: Bean-to-cup espresso machine

Error codes ↓

Eversys Cameo range error codes

Code	Meaning	Likely cause	What to do
E-010	Software does not support this CPU	Version mismatch	Update the software; replace the CPU if it stays.
E-011 / E-012 / E-013 / E-014 / E-023	Hydraulic / milk / brewing / grinder / pump unit not connected	Cable or unit	Check the connection.
E-017	Coffee boiler overheating	Overheat	Machine goes to standby; call service.
E-021	Grinder motor ran non-stop, power cut	Likely a failed triac on the power board	Call service.
E-050	CPU-to-CPU communication error	CAN link failure	Restart; call service if it repeats.
E-094	Standby after boiler overheat	Overheat	Call service.
E-095	Software update running		Wait.
E-097	Machine type not set	Display and CPU types differ	Set the machine type.
E-098	Software update needed	Display and CPU software differ	Run the update.
E-099	Display lost the CPU over 30 s	Link interrupted	Display restarts itself; otherwise switch off at the main switch for 10 s.
E-102 / E-103	Steam boiler empty / fill timeout	Water tap shut or supply problem	Open the water and press Continue. Hot water and steam are locked until then.
E-104	Steam heating timeout	No pressure after 20 min (start) or 10 min (running)	Check element and controls.
E-105 / E-106 / E-107	Steam boiler connector missing / overheating / pressure sensor fault	Wiring or sensor	Check the sensor and cable.
S-002 / S-003	Left / right bean hopper missing	Not seated	Refit the hopper.
S-004 / S-006	Empty the grounds drawer	Drawer full or cleaning about to start	Empty it.
S-007 / S-008 / S-009	Grounds drawer not inserted	Drawer out or sensor	Refit the drawer.
S-010 / S-011 / S-012	Bean hopper empty or locked	No powder found in the chamber	Refill or unlock the hopper.
S-014	Rinse needed	Boiler may not heat until rinsed	Press the rinse key.
S-015 / S-016	Cleaned without cleaning balls	Dispenser empty, ball stuck, or light barrier dirty	Refill / clear it. Coffee is locked until the next proper clean.
S-017	Cleaning needed	Cleaning due	Hold the rinse key 3 s to start cleaning.

For licensed technicians only. This equipment can involve mains voltage, high-voltage microwave circuits, gas and refrigerant. Isolate power (and gas) before opening panels, follow the manufacturer's manual and your local licensing rules (for example ARC refrigerant handling and electrical or gas licences). Wrong settings can spoil food or damage equipment. Check every value on the unit in front of you before changing it.

Based on: Eversys Cameo user manual 5700105622. Always check the manual for your exact model and software version.

ServiceModes is not affiliated with Eversys or any other manufacturer. Written in our own words from the manufacturer's documentation.