Traulsen Intela-Traul control (R, A and G series)

Microprocessor control with a relay module behind the display. It uses three sensors: cabinet air (green), evaporator coil (blue) and liquid line (yellow).

What it is: Reach-in refrigerator / freezer control. Alarm words apply to controls from 2010 on. Sn1–Sn3 and cLO / cHI are the alternative forms some versions show.

Traulsen Intela-Traul control (R, A and G series) error codes

CodeMeaningLikely causeWhat to do
CAL SErLow refrigerant chargeLeak or underchargeRepair the refrigeration system.
LO CAb / cLOCabinet too coldControl or sensor problemClears once the cabinet is back in range.
HI CAb / cHICabinet too warmDoor left open, frozen coil, airflowClears once the cabinet is back in range.
dor OPnDoor openDoor left open or switchClose the door.
ELE LOSPower was lostPower cutPress Alarm Cancel.
CLn FILClean condenserDirty condenser coilClean the condenser.
CoL Snr / Sn2Coil sensor open or shortedBlue sensorReplace the coil sensor.
CAb Snr / Sn1Cabinet sensor open or shortedGreen sensorReplace the cabinet sensor. A reading of -40 means open.
dIS SnrDischarge line sensor open or shortedSensorReplace it.
Sn3Liquid line sensor open or shortedYellow sensorReplace it.
dEF ErrDefrost ended on time, not temperature, for 72 hoursDefrost heater or coil sensorTroubleshoot the defrost cycle.

Notes

For licensed technicians only. This equipment can involve mains voltage, high-voltage microwave circuits, gas and refrigerant. Isolate power (and gas) before opening panels, follow the manufacturer's manual and your local licensing rules (for example ARC refrigerant handling and electrical or gas licences). Wrong settings can spoil food or damage equipment. Check every value on the unit in front of you before changing it.

Based on: Traulsen master service manual TR36015 (Intela-Traul section). Always check the manual for your exact model and software version.

ServiceModes is not affiliated with Traulsen or any other manufacturer. Written in our own words from the manufacturer's documentation.

Back to top ↑