Ice-O-Matic UCG Gourmet undercounter (UCG060–UCG130)

Self-contained gourmet (top-hat) cube maker. A single PC board shows faults with a green power LED, yellow bin-full and freeze LEDs and a red alarm LED, plus a red warning light on the front.

What it is: Undercounter gourmet cuber

Key combo: Push button: 2–5 s during water fill = cleaning mode; over 5 s skips the fill or flips between freeze and harvest.

Ice-O-Matic UCG Gourmet undercounter (UCG060–UCG130) error codes

LightsMeaningLikely causeWhat to do
Red alarm LED steadyCondenser too hot (about 70 °C / 160 °F)Dirty condenser, fan motor fault, or room above about 40 °CFix the cause, then switch off and on. It restarts with the 5-minute water fill.
Red alarm LED flashingEvaporator still above 0 °C after 15 minutes of freezeShort of refrigerant, hot gas valve stuck open, etc.Find the refrigeration fault, then restart.
Yellow freeze + red alarm steadyCondenser sensor faultSensor open or shortedCheck or replace the condenser sensor.
Yellow freeze + red alarm flashingEvaporator sensor faultSensor open or shortedCheck or replace the evaporator sensor.
Yellow bin LED steadyBin full, unit stoppedNormalRestarts when ice is used.
Yellow bin LED flashingCleaning mode, or stopped after a test runCleaning in progress or TEST jumper fittedFinish cleaning / remove the TEST jumper.
Green LED flashing60-minute start-up delay runningDelay jumper setPress the button to skip the delay.
All LEDs flashingUnit stopped after the 3-minute testTEST jumper fittedRemove the jumper and restart.

How to enter service / parameter mode

  1. Test mode: fit the TEST jumper on the PC board and switch on. Every load runs for up to 3 minutes, then the unit stops with all LEDs flashing.
  2. Cleaning mode: during the water fill, hold the button 2–5 s.

Other useful key presses

TaskHow
Force harvestHold the button over 5 s during freeze.
Force freezeHold the button over 5 s during harvest or water fill.
Skip start delayPress the button during the 60-minute delay.

Notes

For licensed technicians only. This equipment can involve mains voltage, high-voltage microwave circuits, gas and refrigerant. Isolate power (and gas) before opening panels, follow the manufacturer's manual and your local licensing rules (for example ARC refrigerant handling and electrical or gas licences). Wrong settings can spoil food or damage equipment. Check every value on the unit in front of you before changing it.

Based on: Ice-O-Matic UCG Gourmet series undercounter service manual. Always check the manual for your exact model and software version.

ServiceModes is not affiliated with Ice-O-Matic or any other manufacturer. Written in our own words from the manufacturer's documentation.

More Ice-O-Matic pages

Back to top ↑